Virtual CD/DVD Server - CDM

System Prerequisites
The Virtual CD/DVDSserver requires the following network components:

Windows 3x/9x/NT, DOS, Novell NetWare, UNIXä, OS/2 Warp, or Internet/Intranet network using 10/100Base-TX.
An Internet web browser loaded on the administration workstation.
Ethernet patch cable to attach the NAS Server to the network.
TCP/IP and NetBEUI enabled on the workstation that will administrate the Virtual DVD Server.

Physical Connection

1. Insert the Category 5 Ethernet patch cable into the RJ-45 connector at the rear of the Virtual CD/DVD Server. Insert the other end into a network hub.
2. Connect the power cable to the Virtual CD/DVD Server and plug it into the power strip or outlet. Use of a surge protector is strongly recommended for long system life.
3. Turn on the Virtual CD/DVD Server.

Front Panel Indicator Lights
There are three LEDs on the front panel of the CDH CPU: LAN, Fault and Power

There are three steps to the system POST (Power On Self Test).

1. Just after the unit is turned on all three CPU LED indicators will light for about 1 second. This indicates that all LEDs as correctly functioning.
2. The Power LED will remain lit through the network initialization process.
3. The Link and Fault lights will flash as the system examines the Flash-ROM.

Click here to begin a step-by-step setup of the Virtual CD/DVD Server.

More advanced uses may wish to browse through the links below for assistance.

Set IP address	Administration web pages
Imaging CDs	Shares
Establishing Security	Protocol Configuration
Dynamic IP	Firmware Upgrade
LED Codes and Resetting to Factory Defaults	User Access (PC and Mac)